Concealed thermostat with inlet system

Concealed thermostat with inlet system

Product recommendations

Rapido T
Thermostatic mixer for concealed installation
35500000
Allure
Thermostat with integrated 2-way diverter
for bath or shower with more than one outlet
19446000
Talentofill
Inlet-, pop-up and waste-system
19952000
Talentofill
Inlet-, pop-up and waste-system
28990000
Stick Showers
Hand shower 1 spray
28034000
Rainshower
Wall hand shower holder
27075000
Rainshower
Shower outlet elbow
27076000
Silverflex
Shower hose TwistStop 1250
28362000

Practical information
Comfortable - the GROHE Aquadimmer is an operating lever that allows choosing between the Talentofill filling valve and hand shower and controls the flow rate at the same time.
Safe - for people with children, we recommend the use of a thermostat fitting, which ensures a constant water temperature to provide protection against scalding.

Installation information
By varying the installation height of the hand shower holder, you influence how far the shower hoses reaches into the bathtub.

To prevent drinking water from being sucked back into the pipe network (see EN 1717), an approved safety device must be fitted when installing a hand shower or a Talentofill filling valve in combination with a bathtub.
Such a device is available in the GROHE accessories range – product number 29 007 000.

Water quantities
To ensure good functioning of this bath solution, a minimum of 7 l of hot/cold water are required per minute at a dynamic supply pressure of at least 1 bar ahead of the thermostat fitting. For faster filling of the bathtub, a higher flow rate is recommended.

General tips for installation
Please make sure that the water volume and the water pressure is adequate so as the waste is sufficiently be dimensioned.